Instructions:ORSE | Oganization for Road System Enhancement

Install the OBE in the correct position!		As written on the operation manual, OBE must be installed in the correct position. Otherwise, it may not work properly at the toll booths. Please get the OBE installed at your local ETC shop.
Has the ETC setup been completed?		ETC will not work if it is not properly setup. Please contact your local ETC shop and have it properly installed.
To set up your OBE in another vehicle	If you change the licence plate of your vehicle, please setup your OBE again with new vehicle information.	Some vehicles cannot use ETC because of technical problem. Please note that certain types of vehicles have windshields that tend to shield the electric wave used in ETC system.
Is your ETC card valid?	If your ETC card has expired, the bar will not open at the toll booth. Check your ETC card’s expiry date again.
Is it inserted in the correct direction?	Please make sure that the card in inserted proper direction and proper side up. Otherwise, it may not work properly at the toll booth. Please read the operation manual carefully.
Do not remove the card while driving	Do not remove your ETC card while going through an ETC lane or right after getting out of the lane. Those actions may cause an error or damage the card.
Go into an ETC lane at a safe speed		Go into an ETC lane at a speed safe enough to stop immediately in an emergency.
Keep a safe distance between vehicles.		Vehicles ahead may stop suddenly for some reason. Please keep a safe distance between your car and the vehicle ahead.
Make sure that the bar is up.		Go into an ETC lane at a speed safe enough to stop immediately in an emergency.
Do not drive reversely		In the case that the bar does not open, do not drive reversely and follow the instructions of the attendant on the interphone.